Leaders in Learning - Mechanical & Materials Engineering
Preliminary Draft 2004-2005


Please review the Preliminary Draft Guide for instructions in using this list.



Please Note: "Type" is listed for your information and will not be included in the final bibliography. Please submit a correction if the type is incorrect for an entry.

Publications

Feng, H.Y.

Feng, H.Y., and Z.J. Teng. 2005 - Jan. Iso-Planar Piecewise Linear Nc Tool Path Generation From Discrete Measured Data Points. Computer-Aided Design 37 (1): 55-64.
Type: Journal Article
Refereed/Peer-Reviewed: YES NO (Please circle)

Tutunea-Fatan, O.R., and H.Y. Feng. 2004 - Sept. Configuration Analysis of Five-Axis Machine Tools Using a Generic Kinematic Model. International Journal of Machine Tools & Manufacture 44 (11): 1235-1243.
Type: Journal Article
Refereed/Peer-Reviewed: YES NO (Please circle)

Tutunea-Fatan, O.R., and H.Y. Feng. 2005 - Feb. Determination of Geometry-Based Errors for Interpolated Tool Paths in Five-Axis Surface Machining. Journal of Manufacturing Science and Engineering-Transactions of the Asme 127 (1): 60-67.
Type: Journal Article
Refereed/Peer-Reviewed: YES NO (Please circle)



Contact Leslie Thomas-Smith, Western Archives at leadersinlearning@uwo.ca with questions or comments.
Last Updated 2006/01/17